MTL Instruments Group
MTL Intrinsic Safety
MTL Signal Conditioning
MTL HART Interfacing
MTL Process I/O™
MTL Industrial Ethernet
MTL Industrial Security
MTL Industrial Wireless
MTL HMI and Visualisation
MTL Surge Protection
MTL Process Alarm Equipment
MTL Gas Analysis
Oil & Gas
Power Generation & Supply
Communications & Telecoms
Food & Beverage
Water & Wastewater
Brochures and Posters
Technical Support Notes
Technical Support Request
Training & Education
Customer Education Courses
Functional Safety Management (FSM)
Channel Selling Guide
There are no legacy products in this category
How can I evaluate the firewalls rules that I’ve created?
How to determine function codes and coil or register addresses for Modbus Enforcer rules?
How do I get started with a Tofino security appliances?
How to free the LSM licenses that are assigned to a missing Tofino?
How to import and use special rules?
What happens if I lose my password to login to CMP?
How does Tofino licensing work?
Can I create backups for my Tofino configuration?
What can’t I discover my Tofino?
Can I move my CMP (central management platform) to another PC? If so, how?
Which USB drive is recommended to be used with the Tofino?
Do I need to use any specific type of USB drive for the Tofino?
Can I use VLAN with Tofinos?
Can switches be protected from unauthorised user access?
Appropriate measures be to protect the devices attached to MTL managed switches from hackers?
Can diagnostic data from a switch on an ethernet LAN be exported into eg a SCADA package?
Can switches be connected to Routers?
Could MTL and Cisco switches reside on the same subnet?
How would I connect from my LAN to the internet to remotely exchange data between separate networks?
How would I connect from my LAN to another LAN to allow network data to be exchanged?
What would be a simple way to check if there is a valid cable connection to a managed switch?
Can the copper port or fibre optic connections on a switch be disabled if required?
How would I know if there was a problem with a Physical copper connection between switches?
How do users assign IP addresses to managed MTLindustrial ethernet switches?
What copper ethernet cable would be needed for Gigabit ethernet connections between switches?
Can a switch function as a router?
Do I need to use a special “cross over” cable to allow communication between a switch?
Will a hub with a transmit speed of 10Mbps Half Duplex be able to communicate with a switch?
Will a PC with a 100Mbps Network Interface Card (NIC) be able to communicate with a switch?
What ethernet protocols can be transmitted through MTL switches?
Are MTL switches mounting orientation sensitive?
What is the alarm relay on a MTL switch used for?
How many switches can be supplied form one power supply?
What would happen if the main and redundant power supplies to a switch are severed?
Can Redundant Ring and RSTP be enabled on the same switch?
Can I use Redundant Ring with another brand of ring switch, or another ring protocol?
Which managed switches support Redundant Ring?
How many rings can I configure using Redundant Ring?
How quickly does the Redundant Ring protocol recover from a failure?
How many switches can I connect in a Redundant Ring?
What is Redundant Ring?
How many switches can I connect in an RSTP network?
Which managed switches support RSTP (Rapid Spanning Tree Protocol)?
Does an unmanaged switch require any setting up to enable it to transmit to other devices?
Can an unmanaged switch be used as part of a Redundant Ring architecture?
Could a MTL unmanaged switch connect to a Hirschmann (or other manufacturers) MANAGED switch?
Can a MTL unmanaged switch connect to a Hirschmann (or another manufacturers) unmanaged switch?
Can a switch be connected to a Wireless ethernet router or access point?
Can MTL switches connect to office grade switches from e.g. HP or Cisco?
Can a Gigabit switch be connected to a Fast Ethernet switch?
Can switches be connected using either copper or fibre optic cable?
Why is Tofino better than other firewall devices?
If a “hacker” manages to obtain a copy of the CMP
Should CMP (Central Management Platform) be always online?
Can you deploy Tofinos in a redundant network?
If a Tofino appliance doesn’t have an IP address
How could a PLC using MODBUS/TCP
My DCS vendor says that their protocol has authentication o
Is a defense-in-depth strategy important for all control systems or
My control system is separated from the business network with a firewall
My control system is never connected to the Internet. Am I still at risk from cyber incidents?
Answers to Frequently asked questions on Azonix could be found below
Answers to Frequently asked questions on Gas Analysers could be found below
On the MTL AC mains panels surge protection cut sheets they indicate the product is for
All standard MTL surge products have a 10 year warranty
What is the advantage of installing AC mains protectio
Most MTL surge protection devices for signal and communication devices indicate t
I have a control cabinet and some transmitters I want to protect
What type of information do I need to know when selecting the correct model surge prote
What type of information do I need to know when selecting the
Should I install a separate ground for the surge protection device?
My transmitter only cost $1,000.00 why should I consider s
Are the Annunciators suitable for use in harsh environments?
What do you use as a signal supply voltage with your annunciator range?
What voltage does the Annunciator operate on?
What does MTL mean when they say this is a 10 year “no fuss” warranty?
Is lightning my only concern when I am considering surge protection?
How can I access MTL Partner portal?
How do I initiate an RMA ( Return Material Authorisation) or Product Return?
What is included in the Tofino™ Starter Pack?
Can a manufacturer such as MTL state their products are
Can the CMP software / Tofino routing through another server?
Even if the incoming phone lines are protected do I need additional protect the telephone lines?
Why is your protection more expensive than others I have found?
All my data lines run inside the building, why do I need to protect them?
Is full protection going to be too expensive?
Why do I need to protect data/control lines?
Are MTL backplanes SIL certified?
Are MTL barriers SIL certified?
We’ve never had any problems with surges, why do we need surge protection?
We are based in an area with very little lightning, why do we need surge protection?
I have product which I would like to use in a SIL loop; as MTL are a certified FSM company can they
We have good grounding, do we still need surge protection?
Our equipment is connected to a UPS, do we still need surge protection?
How do I preform a factory reset on an MTL9211-ET Tofino hardware unit?
As MTL are a certified FSM company can they provide guidance in developing a SIL loop?
Is it true that if a safety loop is designed as SIL2 then all the individual components in that loop
What is a safety manual?
MTL 55xx series of products are certified for use in hazardous areas so could they all be allowed to
What types of communication buses or protocols are applicable for SIL 2 or SIL 3 systems?
Eaton’s MTL830C range multiplexers adds RoHS compliance and improved form factor
New Tofino industrial security solution adds fibre optic capabilities
Absolutely no room for defects with our new Ersa soldering systems
New highest performing modular Surge Protection Device for complete process reliability
New platform of HMI workstations optimise productivity and increase plant safety
Measurement Technology Limited, UK legal entity change - Effective 1st September 2016
New Intrinsically safe ethernet interface reduces installation time
Intrinsically safe ethernet solutions enhance safe plant operation
New next generation Tofino solution for plant protection from cyber-attacks
New Whitepaper Assesses Ex ic - Intrinsic Safety’s New Protection Level
NEW range of HART multiplexers for access to valuable process data
New Segment Calculator Tool for FOUNDATION™ fieldbus networks
Eaton support Yokogawa with its New CENTUM® VP R6.01 Integrated Production Control System
New range of Signal Conditioners for general purpose applications
High performance, next generation Azonix Barracuda 15 workstation
New Ex ic solution for easy, effective fieldbus connectivity
Next generation in Biogas measurement - The MTL GIR6000 Biogas Analyser
New Generation of MTL GECMA Hazardous Area Remote Terminals
MTL is now a certified Functional Safety Management (FSM) company
MTL4850 Hart Multiplexer gains SIL3 rating for functional-safety related loops
NEW MTL Surge protector eliminates threat of power crossover
MTL Technical Support now available on-line
MTL Instruments supports automation in UK manufacturing
NEW Ethernet products from MTL provide harsh & hazardous connectivity across the process plant
Honeywell selects Tofino™ MODBUS Read-Only firewall
MTL Diagnostic Module offers FDT/DTM Interface
Free Fieldbus segment calculator software released for new Fieldbus Barrier
Tofino™ gets OPC Firewall Security Module
New Fieldbus Barrier provides low cost safety in hazardous areas with high reliability
Fieldbus diagnostics module gets Enhanced EDDL
Challenger HMI with Wi-Fi access selected for biotech facility
Invensys adopts Tofino security solution for Triconex OPC
Hitech Instruments deliver cost savings and green energy
The Worlds Largest Foundation Fieldbus Project
FISCO ic and FNICO are interchangeable…for now - A Control Design.com article
New Tofino™ Event Logger module records SCADA security events and alarms
NEW Explosion Proof Alarm Annunciator from RTK
New wall mounting annunciators from RTK
Lloyd’s Register certifies FP32 SPDs for offshore ships and floating platforms
Hima-Sella uses MTL4500 Isolators for production line simplification
BP adopts MTL Redundant FISCO solution
Tofino to be used in Honeywell OneWireless Firewall
MTL supply Intrinsically Safe Ethernet solution to CIBA
Enable your process security with the new Tofino™ Starter Pack
RTK launch SIL2 Annunciator certified to IEC61508
New Tofino™ VPN module secures remote SCADA communication
MTL presents Network Security in Saudi Arabia
MTL Fieldbus Calculator now includes Redundant FISCO power supply
MTL updates its SmartPlant™ library to include next generation fieldbus power supplies
MTL opens new headquarters facility in U.K.
MTL supply FOUNDATION Fieldbus™ solution for Saudi Aramco Project
IS certified Profibus PA monitor simplifies commissioning
New Fieldbus power module drives segment trunks beyond 1km boundary
MTL UK sales e-news Issue 16
MTL wins Readers Choice Award for Intrinsic Safety
New ARC Report - MTL: Expanding Opportunities with a Focus on Fundamentals
Tofino™ Enforcer™ revolutionises Modbus TCP/IP security
MTL first to provide full redundancy for FISCO
Secure Asset Management now available for Tofino™ users
Intrinsically Safe Ethernet gives access to Zone 1 and Zone 0 hazardous areas
“ONE-CORE” technology powers next-generation Intrinsically safe isolators
MTL launches unique diagnostics module for FOUNDATION Fieldbus ™ monitoring
MTL launches Tofino™ Industrial Security Solution following successful beta testing
The MTL Instruments Group plc acquires Ocean Technical Systems Limited
The MTL Instruments Group plc acquires RTK Instruments
The MTL Instruments Group plc acquires Elpro International for £12m
MTL tops readers poll for Intrinsic Safety Barriers
Preliminary Results for year ending
MTL wins prestigious safety award
New fieldbus temperature multiplexer can save up to 70%
MTL launches ‘second generation’ Fieldbus Barrier with improved performance
MTL forms Industrial Networks group to support emerging technologies
Industrial Ethernet Networks get an Intrinsically Secure™ solution
MTL’S NEW HART ® COMMS DTM AVAILABLE FREE OF CHARGE
MTL PREPARES FOR MAJOR
MOST SIL 2 SafetyNet Receives
New fieldbus wiring hubs give 25% capacity boost
MTL and Weidmuller announce
FIELDBUS MONITOR SIMPLIFIES COMMISSIONING OF FIELDBUS SEGMENTS
Preliminary Results for year ending
NEW 8-SEGMENT FIELDBUS POWER SYSTEM OFFERS FREE REDUNDANCY!